Specifications
Philips Fortimo HBMt Gen 3 System Design In Guide 11
Connection between module and driver
The Fortimo High Brightness Module is compatible with both Rset1 and Rset2
Xitanium LED drivers. Using the Rset on the module with these drives, will provide
an output current specied for the module type.
We advise to use the Fortimo LED HBMt Gen3 in combination with the Xitanium
LED drivers mentioned in Tables 2 to 5 (approved combinations).
Cable
The module can be connected to the driver using the cables specied in Tables 2
to 5.
Table 13. Fortimo 7PA to 6wire cable color coding
Table 14. Fortimo LED HBMt Gen3 connector pins
Dimensions in mm
(NOMINAL±0.2MM)
A1 A2 A3 A4 A5 A6 B1 B2 B3 B4 C1 C2 D1
Fortimo LED HBMt,
all types
107.8 30 58.8 70 41.4 13.5 46 36 14.5 6.2 4 8 3.3
Electrical characteristics
Figure 16. Cable wiring to driver
Figure 15. Cable Fortimo 7PA to 6wire - 600 mm
(929000803903)
Figure 14. Cable Fortimo 7PA to 6wire - 600 mm
Connector Signal Destribution
Pin 1 IDC LED driver current input
Pin 2 (HV spacer) Not connected
Pin 3 PGND Power ground
Pin 4 NTC Temperature sensor (RNTC) resistor in series
Pin 5 Rset2 Resistor for current setting of LED driver type Rset2
Pin 6 Rset1 Resistor for current setting of LED driver type Rset1
Pin 7 SGND Signal ground
Connector pin Function Color coding drive/cable
Pin 1 LED+ Red
Pin 2 - No wire
Pin 3 LED- Blue
Pin 4 RNTC Black/White
Pin 5 Rset2 Yellow/Black
Pin 6 Rset1 Yellow
Pin 7 Common Blue/White
Note: It is possible to connect two or more modules in series to one Xitanium driver
by using multiple cables. It is important to note that the driver can only communicate
with one of the modules (master/slave), see Installation instructions.
Note: The Rset2 wire should be left unconnected when Rset1 drivers are used, and
vice versa.