Operating instructions

2.3 How to Connect

Using Your Antenna or Cable for TV

Note: It is strongly recommended that you connect the antenna/cable input using a 75-ohm coaxial cable to

receive optimum picture quality.

1. Turn off the TV.

2. Connect the coaxial (RF) connector from your antenna or cable (out-of-the-wall, not from the Cable Box) to

the ANTENNA connector at the rear of the TV

3. Turn on the TV.

4. Select TV using the SOURCE button on the Remote control or the INPUT keypad on the side of the TV, or

pressing the TV button on the Remote Control.

5. Connect the AV OUT and AV IN of the other TV, the signal will display on the other TV.

Using the Antenna or Cable for your VCR

1. Turn off the TV.

2. Connect the “Output to TV”, “RF Out” or “Antenna Out” connector on the rear of your VCR to the ANTENNA

connector at the rear of the TV.

3. Turn on the TV.

4. Select TV using the SOURCE button on the Remote control or the INPUT keypad on the side of the TV or

directly by pressing the TV button on the Remote Control.

5. Connect the AV OUT and AV IN of the other TV, the signal will display on the other TV.