Specifications

20” LCD TV Color Monitor AOC L20S421

4. Input/Output Description

4.1 D-SUB Connector

This procedure gives you instructions for installing and using the LCD TV display.

1. Position the display on the desired operation and plug the power cord into a convenient AC outlet.

Three-wire power cord must be shielded and is provided as a safety precaution as it connects the chassis

and cabinet to the electrical conduct ground. If the AC outlet in your location does not have provisions for

the grounded type plug, the installer should attach the proper adapter to ensure a safe ground potential.

2. Connect the 15-pin color display shielded signal cable to your signal system device and lock both screws

on the connector to ensure firm grounding. The connector information is as follow:

11 15

15 - Pin Color Display Signal Cable

Pin No. Description Pin No. Description

1 Red Video 9 No Pin!

2 Green Video 10 Sync Ground

3 Blue Video 11 Not Used

4 Not Used 12 Serial Data for DDC

5 Ground 13 H-Sync.

6 Red Ground 14 V-Sync.

7 Green Ground 15 Serial Clock for DDC

8 Blue Ground

3. S-Video ( Y /C ): TV rear side : 4 pin Mini-DIN female

Component Video: TV rear side : RCA female ( Red / Blue / Green )

TV: TV rear side : IEC type female

AV : TV rear side : RCA female (Yellow )

AV/HD Audio: TV rear side : RCA female (Red / White )

PC Input audio: 3.5mm Stereo female

Audio Input for AV,S-Video, Component Video : RCA female ( Red / White )

Headphone 3.5mm female

Audio Output ( to external speaker )

4. Apply power to the display by turning the power switch to the "ON" position and allow about ten seconds

for Panel warm-up. The Power-On indicator lights "GREEN" when the display is on.

5. With proper signals feed to the display, a pattern or data should appear on the screen, adjust the

brightness and contrast to the most pleasing display, or press auto-adjust to get the best picture-quality.

6. This TV (with PC function) has power saving function following the VESA DPMS. Be sure to connect the

signal cable to the PC.

7. If your TV requires service, it must be returned with the power cord.