Service manual

6
3. Operating Instructions
3.1 General Instructions
Press the power button to turn the monitor on or off. The other control knobs are located at front panel of the monitor
(See Figure ). By changing these settings, the picture can be adjusted to your personal preferences.
* The power cord should be connected.
* Press the power button to turn on the monitor. The power indicator will light up.
3.2 Control Buttons and Connections
Power
Press the Power button to turn on/off the monitor.
Eco Mode /DCR/ <-
Press the Eco key continuously to select the Eco mode/DCR of brightness when there is no OSD ( Eco mode hot
key may not be available in all models).
Volume / >
When there is no OSD, press Volume > to active volume adjustment bar, press < or > to adjust volume.
Auto / Exit
When the OSD is closed, press Auto button 2S will be auto configure hot key function .
Source hot key
When the OSD is closed, press Source button will be Source hot key function. Press Source button continuously
to select the input source showed in the message bar , press Menu/Enter button to change to the source selected.