User Manual

50
Windows 2000
1. Start Windows® 2000
2. Click on the 'Start' button, point to 'Sett i ngs ', and then click on 'Control Panel'.
3. Double click on the 'Display' Icon.
4. Select the 'Settings' tab then click on 'Advanced...'.
5. Select 'Monitor '
- If the 'Properties' button is inact i v e, it means your monitor is properly confi gured. Pleas e stop installation.
- If the 'Properties' button is active. Click on 'P r operties' butt on. Please follow the steps given below.
6. Click on 'Driv er' and then click on 'Update Dri ver...' then click on the 'Next' button.
7. Select 'Disp l ay a list of the known drivers for this device so that I can choose a specific driver', then click on
'Next' and then click on 'Have dis k...'.
8. Click on the 'B rowse...' button then select t he appropriate drive F: ( CD-ROM Drive).
9. Click on the 'Open' button, then click on the 'OK' button.
10. Select your m onitor model an d c l ick on the 'Next' button.
11. Click on th e 'Finish' button t hen the 'Close' button.
If you can see the 'Digital Signature Not Found' window, click on t he 'Yes' button.
Windows ME
1. Start Windows® Me
2. Click on the 'Start' button, point to 'Set tings', and then click on 'Control Panel'.
3. Double click on the 'Display' Icon.
4. Select the 'Settings' tab then click on 'Advanced...'.
5. Select the 'Monitor' button, then click on ' Change...' button.
6. Select 'Specify the location of the dri ver(Advanced) ' and click on t he 'Next' button.
7. Select 'Disp l ay a list of all the drivers in a specific location, so you can choos e the driver you want', then click
on 'Next' and then click on 'Have Disk...'.
8. Click on the 'B rowse...' button, select the ap propriate drive F: ( CD-RO M D rive) then click on the 'OK' button.
9. Click on the 'OK' button, select your monitor model and click on the 'Next' button.
10. Click on 'Fi nish' button then the 'Close' button.