CT700G CT710G CT720G CT740G User’s Manual 2
Thank you very much for choosing the AOC Color Monitor. We recommend that you take a few minutes to read carefully through this brief but comprehensive manual before installing and switching on the monitor. Please keep this manual in a safe place for you future reference. Plug & Play Drivers for the AOC Series Monitors are available at: www.aocmonitor.com CHECKING THE CONTENTS OF THE MONITOR PACKAGE The product package should include the following items: 1. 2. 3. 4. 5.
TECHNICAL SUPPORT(FAQ) Plug & Play DDC1/2B Feature This monitor is equipped with VESA DDC1/2B capabilities Power LED is not on according to the VESA DDC STANDARD. It allows the monitor to *Power Cord should be connected inform the host system of its identity and, depending on the level No Plug & Play of DDC used, communicate additional information about its display *Check if the PC System is Plug & Play compatible capabilities.
OPERATING INSTRUCTIONS GENERAL INSTRUCTIONS The other control knobs are located at the base of the monitor (See Figure 3). By changing these settings, the picture can be adjusted to your personal preferences. The power cord should be connected. Connect the video cable from the monitor to the video card. To turn the monitor on, press the power switch to ON position. The power indicator will light up.
CONNECTING CABLES 1. Power Cord 2. Signal Cable 3. VGA Card Adapter 4. 5. PC Audio Output DC Output EXTERNAL CONTROLS 1. Shuttle Knob 2. Power Indicator 3. Power button HOW TO ADJUST A SETTING 1. Press the Shuttle Knob Key to make the OSD window appear. See figure 4. 2. Rotate the Shuttle Knob to select the desired function. See figure 4. 3. Press the Shuttle Knob again to select the function that you want to adjust. 4. Rotate the Shuttle Knob to change the settings of the current function. 5.
5. V- CENTER Adjust the vertical position of the picture. 6. V- SIZE Adjust the picture’s vertical size. 7. ZOOM Adjust the picture’s horizontal and vertical size simultaneously. 8. PINCUSHION Adjust the pincushion and barrel 9. TRAPEZOID Adjust the picture’s trapezoid distortion. 10. PIN-BALANCE Adjust to compensate the pincushion unbalance. 11. PARALLELOGRAM Adjust the picture to be a rectangle. 12. ROTATION Adjust the picture tilt to horizontal position.
SPECIFICATION CRT Viewable Image Size Video Separate Sync. H/V-sync. Scanning Frequency: Horizontal Vertical Max. Resolution Video Dot Rate Factory Preset mode : User Programmable mode : Power Source Operating Humidity Dimension CT700: CT740: Weight CT700: CT740: Signal Cable Plug & Play EPA ENERGY On mode STAR® Off mode Power consumption Preset display area Audio output (CT740 only) Regulations Factory Preset Timing Table 43.2cm(17"), 90º deflection, 29mm neck, 0.23mm(H), 0.27mm(D) dot pitch 40.
