CT500G User’s Manual 2 J
Thank you very much for choosing the AOC Color Monitor. We recommend that you take a few minutes to read carefully through this brief but comprehensive manual before installing and switching on the monitor. Please keep this manual in a safe place for you future reference. Plug & Play Drivers for the AOC Series Monitors are available at: www.aocmonitor.com CHECKING THE CONTENTS OF THE MONITOR PACKAGE The product package should include the following items: 1. Monitor 2. Owner's Manual 3.
Plug & Play DDC1/2B Feature This monitor is equipped with VESA DDC1/2B capabilities according to the VESA DDC STANDARD. It allows the monitor to inform the host system of its identity and, depending on the level of DDC used, communicate additional information about its display capabilities. The communication channel is defined in two levels, DDC1 and DDC2B. The DDC1 is a unidirectional data channel from the display to the host that continuously transmits EDID information.
Figure 1 Installing and Removing the Swivel Base Figure 3 External Control Knob Figure 4 The OSD Message 536 Figure 2 800 X 600 Connecting Cables EXTERNAL CONTROLS 1. 2. 3. 4 5 6 1. Switch: Power On/Off Switch LED Menu Contrast Brightness.
INSTALLATION INSTRUCTIONS SWIVEL BASE To attach the swivel base to the monitor, do the following: Carefully turn the monitor on its side or upside down. (see figure 1) Locate the cavities at the bottom front of the monitor. Insert the pegs on the swivel base into these cavities. Push the swivel base forward until the swivel base locks in place. To remove the swivel base, hold the bottom of the swivel base, then push it out. POWER CORD Power Source: 1.
ADJUSTING THE PICTURE (See Figure 3) 1. CONTRAST Adjust the picture contrast. 2. BRIGHTNESS Adjust the picture brightness. 3. H- CENTER Adjust the horizontal position of the picture. H- SIZE Adjust the picture’s horizontal size. V- CENTER Adjust the vertical position of the picture. V- SIZE Adjust the picture’s vertical size. 7. ZOOM Adjust the picture’s horizontal and vertical size simultaneously. 8. PINCUSHION Adjust the pincushion and barrel 9.
Factory Preset Timing Table SPECIFICATION CRT Viewable Image Size Video Separate Sync. H/V-sync.: Scanning Frequency: Horizontal Vertical Max. Resolution Video Dot Rate Factory Preset Timings : User mode Timings : Power Source Operating Humidity Dimension (Monitor&Base) Weight (Net) Signal Cable Plug & Play EPA ENERGY STAR® Power consumption Preset display area Regulations 38.1cm(15"), 90º deflection, 29mm neck, 0.24mm(H), 0.28mm(D) dot pitch 35.1cm (13.8"), diagonal 0.
