User`s manual

5). When adjustment about white is ok, changes signal to P822 that Gray steps picture. The
Gray picture has no deflection color, and the Gray steps distinguish 28 steps from 32steps
Note: The white balance is adjusted in the course, will influence each other to adjust in the
adjustment of gray steps and white picture, and need to change repeatedly.
Please notice that can't enter the mode of the factory in every station homework after adjusting
and finishing, so as not to miss movements and revise the white balance data again.
VGA Adjustment
Setting of Chroma2326 as follows:
Gray picture: TIM4/PAT48
White picture: TIM4/PAT105
Change to VGA mode, press “CH+/-”and adjust following items. Method same as AV mode:
6. White.BRoVga (vMin=0,vMax=100,vDef=50) →50,
7. White.BBoVga (vMin=0,vMax=100,vDef=50) →50,
8. White.BGoVga (vMin=0,vMax=100,vDef=50) →50,
9. White.BRgVga (vMin=0,vMax=100,vDef=50) →50,
10. White.BBgVga (vMin=0,vMax=100,vDef=50) →50,
Note: Press “Source” and change mode that Video Rear to VGA, then adjustment items of
white balance same as Video Rear First, press “CH+/-” and adjust under the VGA mode.
(White.BBgCVBS(vMin=0,vMax=100,vDef=50)→50 CVBS change to VGA）
COMPONENT Adjustment:
1). VG828 setting as follow：
Gray picture：TIM954/PAT922
White picture：TIM954/PAT936
2). Change to COMPONENT1 mode，press “CH+/-”and adjust following items. Method same
as AV mode：
1. White.BRoVga (vMin=0,vMax=100,vDef=50) →50,
2. White.BBoVga (vMin=0,vMax=100,vDef=50) →50,
3. White.BGoVga (vMin=0,vMax=100,vDef=50) →50,
4. White.BRgVga (vMin=0,vMax=100,vDef=50) →50,
5. White.BBgVga (vMin=0,vMax=100,vDef=50) →50,
Adjustment stand of white Balance： x=299±15，y=315±15
Page 26 of 83