Product Overview

©October 2015 A. O. Smith Corporation. All rights reserved.
www.hotwater.com | 800-527-1953 Toll-Free USA | A. O. Smith Corporation | 500 Tennessee Waltz Parkway | Ashland City, TN 37015
Page1 of 2
AOSCG10700
ADVANCED ELECTRONIC CONTROL
• Has a solid state ignition surface that does
not flutter or blow out.
• Provides increased reliability and efficiency
over spark ignition systems. Eliminates the
pilot and saves energy.
• Temperature adjustable up to 181° F.
POWERED VENTING
• Provides more venting flexibility and savings.
A new quiet blower allows exhaust venting
through the roof or sidewall with plastic pipe
such as PVC, CPVC, ABS, and polypropylene.
• Up to 125 equivalent feet of pipe make
installation easy in any situation.
• BTF-80 is a Category 3 (positive pressure
non-condensing) appliance.
CFC-FREE FOAM INSULATION
• Minimizes radiant heat loss.
DIP TUBE
• Carries inlet water deep into tank.
USER-FRIENDLY
• State-of-the-art electronic gas control
provides more precise temperature control.
• LED control light displays operation status
and diagnostics information.
ENHANCED-FLOW BRASS DRAIN
VALVE
• Have a solid brass, tamper resistant,
enhanced-flow, ball type, drain valve.
• Uses a standard female hose fitting that
allows for fast and easy draining during
maintenance.
• Designed for easy operation, this valve
includes an integral screwdriver slot that
features a ¼ turn (open/close) radius, which
not only permits full straight-through water
flow but also a quick and positive shut off.
BLUE DIAMOND
®
GLASS COATING
• Provides superior corrosion resistance
compared to the industry-standard
glasslining.
ANODES
• Tank-mounted, screw-in magnesium anodes
for longer tank life.
HIGH INPUT
• 76,000 BTU input assures plenty of hot
water is available by providing faster
recovery rates and higher first hour draws.
BURNER
• High input, multiport burner for improved
combustion efficiency and low NOx.
BUILT-IN CONDENSATE FITTING
• A condensate management coupling
that attaches vent pipe to the blower is
included.
INSTALLED TEMPERATURE &
PRESSURE RELIEF VALVE
• Factory installed and matched to the heater.
(Specify if your local code requires a special
T&P).
MAXIMUM HYDROSTATIC WORKING
PRESSURE 150 PSI
STANDARDS AND CERTIFICATIONS
• Design-certified by CSA International,
according to ANZI Z21.10.3 - CSA 4.3
standards governing storage-type water
heaters.
• Meets the thermal efficiency and standby
loss requirements of the U.S. Department
of Energy and current edition of ASHRAE/
IESNA 90.1.
• Meets Texas and other low NOx areas
requiring 40ng/j
• All models are approved for use in
combined appliance applications.
• Not recommended for sanitation rinse.
3-YEAR LIMITED TANK / 1-YEAR
LIMITED PARTS WARRANTY
• For complete warranty information, consult
written warranty or go to hotwater.com.
CONSERVATIONIST
®
POWER VENT
Commercial Gas
Water Heaters
BTF-80
SERIES 210/211