Brochure

14
BTR
Gas Models
80% thermal efficiency, self-cleaning,
easy to install
The Master-Fit
®
BTR series provides outstanding performance and maximum
installation flexibility for both new construction and replacement applications.
Each unit is designed to be as much as a foot shorter than the models they usually
replace, and multiple options for placement of water connections and low
installation clearances are additional installer-friendly features.
The Eliminator
™
Self-Cleaning System
As deposits of lime and other sediments accumulate inside the tank, they form a
barrier between the burner and the water, concentrating heat around the
critical weld areas. The result is reduced energy efficiency, higher operating
costs, and a greater risk of premature tank leaks. The Eliminator
™
directs
incoming cold water under pressure to sweep the bottom of the tank to
keep sediment moving so it doesn’t accumulate. Reduced sediment
build-up helps maintain rated thermal efficiency and reduce water
heating costs.The self-cleaning system also helps prolong tank life
to ensure year after year of reliable service.
Factory-Installed Draft Diverter
And Flue Damper
n
Low-profile draft diverter helps
for installation in tight spaces
n
Automatic motorized flue damper
helps minimize standby heat loss
Three Water
Connection Options
n
Hot and cold water connections
can be made through front, top or
rear of unit
n
The Eliminator
™
system operates
when cold water is connected
through front
PermaGlas
®
Ultra Coat
™
Glasslining
n
Exclusive process provides superior
protection against corrosion
n
CoreGard
™
anode rods with
stainless steel core provide
additional corrosion protection
Optional Power Vent
Kit Systems
n
BTR 120-200 p/n 9005381205
n
BTR 250-500 p/n 9003434205
Intermittent
Electronic Ignition
n
Eliminates standing pilot,
saves energy
n
Includes power ON/OFF switch
n
Provides flame failure response in
less than one second
Meets the Thermal efficiency
and standby loss requirements
of the U.S. Department of
Energy and current edition of
ASHRAE/IESNA90.1
CSA Certified and ASME Rated
T&P Relief Valve,
Factory-Installed
Maximum Hydrostatic Working
Pressure: 160 PSI
Fully Automatic
Control System
n
Manual-reset gas shutoff
device prevents excessive
water temperature
n
Electric temperature control for
precise temperature regulation
adjustable 120ºF–180ºF
n
Gas pressure regulator and
pilot filter
Handhole Clean Out
n
Allows easy access to tank interior
for cleaning
3-Year Limited Tank Warranty
5-Year Limited Tank Warranty
Optional
AOSCA80000 R July 2014 Commercial Catalog_108078_ResidentialFul#7A635.qxd 7/16/14 4:26 PM Page 14