Installation Guide

8
Have questions? Call us at 1-844-44-ANZZI or visit us at www.ANZZI.com
Rubber pad
Filter
Connecting water pipes
1
3
2
2.Connect the water supply hose to the tee joint.
Throttle valve
1.
Note: The throttle cover and throttle 0-RING in the throttle valve shall be removed in the following two cases.
a.When the inflow pressure is less than or equal to 0.05 MPa dynamic pressure. (e. G., domestic water tower, etc.)
b.When the cover plate is installed and used, the nozzle cannot be sprayed normally.
Disassembly steps：1、Use pliers and other tools to clip the throttle valve out of the water inlet pipe.
2、Remove throttle cover and throttle 0-RING. (Sealed 0-RING to be retained)
3、Reinstall the throttle valve into the inlet pipe.
Special reminder:
When the inlet pressure is ≥0.1MPa, the throttle cover and throttle 0-RING must be retained
in the throttle valve.
Throttle bonnet
Throttle 0-RING
Sealed 0-RING
4.
3.
Prohibit
1.It is strictly prohibited to move products from the toilet lid, which is easy to
cause mechanical failure.
2.It is strictly prohibited to receive hot water above 40℃ and cold water that
will freeze.
Close the angle valve and remove the water supply hose connected to the
water tank.
The tee joint is connected to the angle valve and ensures that the
rubber sealing ring is installed therein.
Open the angle valve to check for
water leakage.
After inserting the filters and rubber pads
at both ends of the water inlet hose into
the water inlet hose, connect the tee joint
and the cover plate.