Installation Sheet

6. Obtain the following measurements:

•Top edge of Glass Door (01) to the upper portion of the top Hinge (05)

•Lower portion of the upper Hinge to the upper portion of the bottom

Hinge

•Lower portion of the bottom Hinge to 1/16” above the shower base.

Use the above measurements to cut the Side strip (06). To cover the

space to the wall, create a notch in the cut strip to allow them to slide

into the Hinge. Take off the timber plate. With Glass Door opened fully,

carefully press the cut strips onto the vertical edge of the Glass Door.

7. Precisely measure the lower portion of the Glass Door (01) from the

Side Strip (06) to the vertical edge on the side with the Handle (02).

Using this measurement, cut the Bottom Anti-Water Strip (07) to size and

create a 3/8” notch in the interior side of the Bottom Anti-Water Strip.

ATTENTION: When the door is shut, the Handle side of the Glass Door

should be tight to the Anti-Water Strip (07) along the vertical edge.

Refer to Figure 7 for details.

ATTENTION: Before moving to the next step, ensure the portion of the

wall involved in installation of the L-Shaped Strip (08) is clean, void of any

construction debris, oil, or soap, and the area is fully dry.

8. Close door and press the Bumper Strip (08) along the edge of the

door.

9. This is the final step for Design “A” products.

INSIDE

OUTSIDE

HANDLE SIDE

STRIP END

GLASS DOOR