Installation Sheet

3. Securely hold the glass door in place and mark drill holes on the wall for both Hinges (05). With holes marked, set the door aside and use a Ø ¼” drill
bit to drill the holes in the wall. Gently set the Glass Door (01) back on the flat timber and adhere the hinges to the wall using two Countersunk Screws
ST5x70 (04) on the hinge from the shower’s exterior.
NOTICE: Due to the heavy weight and hinges on the door, it MUST be affixed to the studs in the wall or, if necessary, a 2x6 wood reinforcement
preinstalled behind the wall.
NOTICE: The drilled holes in the wall are very close to the backplate of the hinge. If care is not taken when installing the long screws or screwdriver may
scratch the back plate.
4. (OPTIONAL) Gently remove the back plates from the Hinges (05) and place the Glass Door (01) in a safe and secure place. Screw in the remaining
Countersunk Screws ST5 x 70 (04) into the wall. Carefully replace the Glass Door to its prior position and reassemble the Hinges.
5. Attach the Handle (02) to the Glass Door (01).
HINGES
A
DETAIL A
WALL
MARK LOCATION
ON WALL
Ø
1
4
"
5
8
" FLAT
TIMBER
INSIDE
INSIDE