Installation Sheet

DESIGN “B”:

ATTENTION: This assembly portion only requires the parts from

Diagram “B” for the assembly and installation of the Support Bar.

NOTICE: The Support Bar* MUST be installed to allow for greater

stability if the width of the Stationary Glass is 12” or greater.

27. Find the Support Bar* (12) and adjust it to an appropriate position

on the glass and wall then level it horizontally. While holding it firmly

in place, make a precise outline of the position of the brackets on the

wall. Carefully remove the Support Bar* and disassemble the wall

bracket. Hold the bracket up to the position you outlined on the wall

and mark the drilling hole.

Using a Ø 5/16” drill bit, drill the hole and insert the Wall Anchor

(13). Use the Big Flat Head Screws* ST4.2x55 (15) to attach the

wall bracket to the wall. View Figure 27.6 then secure the glass by

fastening the Support Bar* to the wall and tighten the set screws and

the glass-holding screw.

28. Carefully add the sealant along the area where the Stationary

Glass meets the wall and along the Shower Base or Threshold. Clean

the silicone using the tool Silicone Cleaner (25).

WARNING: WAIT 24 HOURS BEFORE USING THE SHOWER

ENCLOSURE TO ALLOW THE SILICONE GEL TO DRY

COMPLETELY.

MARK

HERE

MARK

HERE

SUPPORT BAR