Installation Sheet

DESIGN “A”:

ATTENTION: This assembly portion only requires the parts from Diagram

“A” for the assembly and installation of the Single Shower Door.

Single Shower Door 23”-30”

Diagram “A” is required for assembly

1. Secure the Hinges (05) to the Glass Door (01). Refer to Figure 1 for

details.

NOTICE: Do NOT place glass directly on a tile surface. To best protect

the glass, ALWAYS lay the glass on a piece of cardboard or wood. Protect

the edges and corns of the glass by keeping the corner pads on the

glass until it becomes necessary to remove them for installation.

2. Position a flat piece of timber (5/8” thick) on the shower base or

threshold. Carefully remove the corner pads from the Glass Door (01) and

place the Glass Door gently on the timber piece. Place the hinged side

of the door adjacent to the wall and carefully butt them together. Make

necessary adjustments to the door position and make sure it is vertically

level.

NOTE: To ensure the door is perfectly plumb, use a leveler tool.

OUTSIDE

DETAIL A

TUB DOOR