Installation Guide

6. Firmly tighten the bottom bolder clip (13) to secure the glass
panel.
7. Next, install the magnetic strip (12) onto the fixed glass panel
(16).
8. Place the hinged side vertical rail (2) on the opposite wall
from the previously installed vertical rail (16). It is very import-
ant that the two rails are positioned parallel to one another and
are both vertically level.
9. Locate and mark where to drill the anchor holes. Once
marked, place the vertical rail (2) aside and drill into the wall
with an 8mm drill and insert the white wall anchors (1).
10. Align the vertical rail (2) to the wall anchors and firmly
screw in with the provided ST5*40 screws (4).
11. Install the pivot base (6)