Installation Guide

6 7 98

12 13 14 15 1611

181920

Fixed Side Seal

Componentlist

Description

Drawing

Qty

NO.

Wall anchor(8)

Vertical rail

Door side seal strip

Bottom pivot base

Door threshold

Door bottom seal strip

Threshold clip

ST4*30

ST5*40

Moving glass panel

Handle

Door magnetic seal strip

Bottom bolder clip

Fixed glass panel

Vertical rail

Shelf to Wall Clip

Shelf to Glass Clip

Shelf glass

Pivot Clips

Structural arm

Wall anchor(6)

NOTE: Unpack your unit carefully and inspect it. Identify all parts using the detailed diagram and packing list

in this manual as a reference. Before discarding the carton, check for small hardware bags that may have

fallen to the bottom of the box. If any parts are damaged or missing, please contact ANZZI at

1-844-44-ANZZI or support@ANZZI.com.

SD-AZ04

SHOWER PANEL SERIES

PAGE 1
SD-AZ04 SHOWER PANEL SERIES Componentlist 22 21 1 20 19 18 17 2 3 4 5 NO.
PAGE 2
Fixed Panel Side Fixed Panel Side 1. Place the vertical rail (16) for the fixed glass panel (14) against the desired wall. Locate and mark where to drill the anchor holes. It is recommended you use a level to ensure vertical rail and the screw holes are perfectly vertical. Once marked, place the vertical rail (16) aside and drill into the wall with an 8mm drill bit and insert the white wall anchors (1). 4.
PAGE 3
6. Firmly tighten the bottom bolder clip (13) to secure the glass panel. 7. Next, install the magnetic strip (12) onto the fixed glass panel (16). 8. Place the hinged side vertical rail (2) on the opposite wall from the previously installed vertical rail (16). It is very important that the two rails are positioned parallel to one another and are both vertically level. 9. Locate and mark where to drill the anchor holes.
PAGE 4
12. Attached the top and bottom pivot clips (21) onto glass door (5). 14. Line up the glass shelf with the holes drilled on the panel. On the shower wall mark where to drill the holes. 13. Attach the door side seal (3) to the glass door (5). 5. Insert the glass to wall clip (18) into the hole in the wall and insert the shelf to glass panel clip (20) to the glass panel. Then tighten to secure.