Installation Guide

Guard Rail
1. Lay the structural guard rail (8) along the ground. Insert the
two wall mounting brackets (7) at both ends of the structural
guard rail. Mark on the wall where to drill the hole to allow the
wall mounting bracket anchors to be installed.
2. Drill the holes with an 8mm drill bit and insert the white
plastic anchors. Before screwing the mounting brackets in place,
insert the rollers (9). Once the rollers are inserted into the guard
rail fix the wall mounting brackets to the wall.
Fixed Panel
3. Install the rubber seal (1) on to the side of the fixed glass
panel (5). Then, install the glass supporting brackets (3) to the
fixed glass panel.
4. Insert the glass panel to the guard rail. On the shower wall
mark where to drill to anchor the glass supporting brackets.
5. Move the glass panel away to make room to drill the 8mm
holes for the supporting brackets and insert a white plastic
anchor. Then screw the supporting bracket into the wall using
the provided screws (6).