Installation Instructions

5. Carefully make an outline on the wall of the Guide Rail Brackets (08)
position. Set aside the Stationary Glass (02) while you disassemble the
Guide Rail Brackets from the Upper Guide Rail (03). Position the Rail
Bracket into the outlined areas and precisely mark drilling holes.
Refer to Figure 6 for details.
6. Use a Ø 3/8” drill bit to drill the holes for the Guide Rail Brackets (08).
Insert the “Large Anchor 3/8” (09).
7. Use the Round Head Screw ST5x45 (10) to mount the male parts of
the Guide Rail Brackets (08) onto both walls.
Refer to Figure 8 for details.
8. Precisely mark drilling holes on the floor using the pre-drilled holes of
the Threshold (15) as a guide. Remove the Threshold. Use a Ø 5/16” drill
bit to drill the holes in the floor then insert the Small Anchors Ø 5/16” (18).
Add silicone on the bottom of the Threshold around the holes and
along the center line. Position it back into its designated place. Use the
Countersunk Screw ST4.2x25 (16) to fasten it to the floor.
NOTE: Avoid damaging the stationary glass with the screws in the
threshold by using the Glass Bottom Protection Seal (21) to cover the
bottom 2 screws of the stationary glass.
GUIDE RAILS
Mark hole
position on
floor
Ø8mm