Specification Sheet

Notice: Leaks and property damage may occur from incorrect installation. Follow all installa-
tion instructions before making final connections and turning on the supplies. Shut off both handles
when not in use or left unattended. Improper use or inadequate drainage below faucet may cause
water damage.
CARE & MAINTANCE
To preserve the finish on the metallic parts of your ANZZI faucet, apply non-abrasive wax, such as
car wax. Any cleaners should be rinsed off immediately.
Clean the aerator regularly for calcium build up or any blockage that reducing water flow.
Connect to 1/2" IPS supply line. The
pipe should extend 1/2" past the
finished wall surface. Using the
Connector[06] if needed.
WARNING: Connect to Cold Water
Only.
Drill 15/64"(6 mm )holes
where marked and install
the Plugs[05].
Wrap plumber tape around pipe
threads. Install the Anchor[04] using
the 4 Screws[03] .
Place Flange[02] onto the faucet as
shown. Thread faucet onto pipe.
Tighten securely, but do not over
tighten.
Tighten Hex Screw[07] in Anchor[04]. Slide Flange[02] over
the wall Anchor[04].
Remove aerator (1)and turn faucet handles (2) to the full on
position. Turn on cold water supply and flush water line for
one minute.
Important: This flushes away any debris that could cause
damage to internal parts.Check all connections at for leaks.
Re-tighten if necessary, but do not over tighten.
Do not full tighten.
Tighten the Hex Screw[07] and
mark the screw holes in the flange.
Unthread the faucet from the pipe.
the short
side for
the