Installation Guide

5
Have questions? Call us at 1-844-44-ANZZI or visit us at www.ANZZI.com
* All ANZZI bathtubs are 100% water tested at the factory and certified to be free of
leaks. Transportation and mishandling may cause leaks. It is necessary to test the
bathtub while there is access to all sides of the bathtub.
TEST THE BATHTUB WHILE YOU HAVE ACCESS TO THE
BOTTOM AND BEFORE PERMANENTLY INSTALLED.
READ AND FOLLOW ALL INSTRUCTIONS
• Place the tub on a completely flat surface in an area where it may be drained after testing.
• Close the drain and fill the tub about half way.
• Allow the water to stand in tub for 30 minutes and then inspect all plumbing and seals for leaks.
CRITICAL: MAKE SURE THE TUB IS PERFECTLY LEVEL TO PREVENT LEAKAGE. USE THE ADJUSTABLE
LEVELING FEET TO ENSURE A LEVEL TUB. ALL LEVELING FEET MUST MAKE CONTACT WITH THE
FLOOR / SURFACE. WHEN A TUB LEAKS, IT’S ALMOST ALWAYS BECAUSE IT’S NOT PROPERLY LEVEL.