Full Product Manual

Have questions? Call us at or visit us at www.ANZZI.com

A) FEET INSTALLATION

St ep 1

1. Lay a towel, blanket , or carboard over the floor.

2. Lay the bat htub on the covering to prot ect it from scratches.

3. Take off the plastic covers of screws and unscrew nuts and washers from the tub (t hese are

pre-assembled on the tub).

4. Follow the diagram below and inst all the crossbar onto the bottom of your batht ub. Do not

tight en yet as adjust ments may be necessary later.

St ep 2

1. See Picture ①. Position the feet to the corner of the tub, and make sure the feet fit snuggly

against the tub's shell (there is no significant gap between tub and feet, the bar needs to be

adjust ed to achieve a good fit).

2. See Picture ②. Once the feet have been adjust ed to a good posit ion, tight en the screw s on

the crossbar. Then use the screw to set the feet on the bar. M ake sure the feet are firmly

secured to prevent movement.

3. Check if the ground is flat or not by using a lever. If the floor is not flat, use the adjustable

wrench to unscrew the nut on the feet, adjust the feet to a proper height , and then tight en the

nut. See Picture③.