FT-AZ077 JARVIS AIR JETTED FREESTANDING BATHTUB WITH CHROMA-LIGHTS INSTALL & OPERATION MANUAL V2.2 DON’T WAIT! REGISTER NOW! Register your product within 30 days to ensure your bathtub is coverage. Mail in the completed registry card (Pg. 2) or register online at www.ANZZI.com/register.
PRODUCT REGISTRATION* IMPORTANT: YOUR WARRANTY WILL NOT BE RECOGNIZED UNLESS THIS CARD IS FULLY COMPLETED AND RETURNED OR ONLINE REGISTRATION IS COMPLETED. To ensure that your warranty is registered and confirmed please do one of the following: 1. Register online at www.ANZZI.com/register. You will be asked to fill out the same information you would in the registration card. Registering online is fast, secure and ensures we receive your information. 2.
FT-AZ077 AIR JETTED FREESTANDING BATHTUB 66.9” INCLUDES: 39.3” AERO-THERAPEUTIC BUBBLE MASSAGE SYSTEM OUTER LENGTH BASIN LENGTH 4 CHROMA-THERAPEUTIC BATHING LIGHTS FEATHER TOUCH LIGHT-UP CONTROL PAD R1.77” DRAIN BUILT-IN OVERFLOW AND POP-UP DRAIN DECK/LIP THICKNESS 33.4” 19.6” BASIN WIDTH OUTER WIDTH 4.9” 23.6” OUTER HEIGHT Power Supply & Control Box Air Blower Have questions? Call us at 1-844-44-ANZZI or visit us at www.ANZZI.
SAVE THIS MANUAL! READ THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING THE PRODUCTS. FAILURE TO DO SO COULD RESULT IN AN IMPROPER INSTALLATION AND COULD VOID THE WARRANTY. RESPONSIBILITY OF THE INSTALLER! THE INSTALLER MUST INSPECT AND WATER TEST THE PRODUCT PRIOR TO INSTALLATION TO ENSURE THE UNIT IS FREE OF DEFECT OR DAMAGE. IN THE EVENT OF A PROBLEM, THE UNIT MUST NOT BE INSTALLED. IF THE CRATE OR THE PRODUCT HAS BEEN DAMAGED DURING SHIPPING, PLEASE CALL US IMMEDIATELY.
SAFETY INSTRUCTIONS READ THESE INSTRUCTIONS COMPLETELY BEFORE INSTALLING THE PRODUCTS. FAILURE TO DO SO COULD RESULT IN AN IMPROPER INSTALLATION AND COULD VOID THE WARRANTY. IMPORTANT SAFETY INSTRUCTIONS. INSTRUCTIONS IMPORTANTES RELATIVES A LA SECURITE. READ AND FOLLOW ALL INSTRUCTIONS. LIRE ET SUIVRE TOUTES LES INSTRUCTIONS. SAVE THESE INSTRUCTIONS. CONSERVER CES INSTRUCTIONS. WARNING: RISK OF ACCIDENTAL INJURY OR DROWNING; CHILDREN SHOULD NOT USE HYDROMASSAGE BATHTUB WITHOUT ADULT SUPERVISION.
UNPACK THE BATHTUB REMOVE THE BATHTUB FROM THE BOX AND PREPARE THE FOLLOWING TOOLS. LEVELER RULER ADJUSTABLE WRENCH TEFLON TAPE FLEXIBLE DRAIN included NOTE: THE INCLUDED FLEXIBLE DRAIN IS TO BE USED ONLY TO TEST THE BATHTUB BEFORE PERMANENT INSTALLATION. IT IS THE RESPONSIBILITY OF THE INSTALLER TO PROVIDE THE PERMANENT DRAIN ASSEMBLY. 6 Have questions? Call us at 1-844-44-ANZZI or visit us at www.ANZZI.
* All JERICHO bathtubs are 100% water tested at the factory and certified to be free of leaks.Transportation and mishandling may cause leaks. It is necessary to test the bathtub while there is access to all sides of the bathtub. TEST THE BATHTUB WHILE YOU HAVE ACCESS TO THE BOTTOM AND BEFORE PERMANENTLY INSTALLED. READ AND FOLLOW ALL INSTRUCTIONS • Place the tub on a completely flat surface in an area where it may be drained after testing. • Close the drain and fill the tub about half way.
INSTALLING THE BATHTUB MOVE THE BATHTUB TO THE SELECTED INSTALLATION POSITION, (MAKE SURE THAT THE FLOOR SURFACE CAN SUPPORT THE LOAD CAPACITY), AND PLACE IS IN THE PROPER (OR DESIRED) ORIENTATION. THEN USE A LEVEL TO ENSURE THE TUB SURFACE IS LEVEL. IF NOT, LIFT ONE END OF THE BATHTUB, AND LOOSEN THE ADJUSTING NUT ON THE TUB FOOT AS SHOWN IN THE FIGURE. AFTER ADJUSTING THE LEVELING FOOT TO A SUITABLE POSITION, THEN TIGHTEN SECURING NUT. WARNING: MAKE SURE THE TUB IS PERFECTLY LEVEL TO PREVENT LEAKAGE.
INSTALLING THE BATHTUB PLUG IN THE ELECTRICAL CORD INTO THE GFCI PROTECTED OUTLET. CONNECT THE DRAIN LINE TO THE TUB DRAIN USING TEFLON TAPE. NOTE: THE INCLUDED FLEXIBLE DRAIN IS TO BE USED ONLY TO THE TEST THE BATHTUB BEFORE PERMANENT INSTALLATION. IT IS THE RESPONSIBILITY OF THE INSTALLER TO PROVIDE THE PERMANENT DRAIN ASSEMBLY. Have questions? Call us at 1-844-44-ANZZI or visit us at www.ANZZI.
FILL THE BATHTUB FINALLY FILL THE BATHTUB WITH WATER. REMEMBER TO ONLY FUN THE AIR JETS WHEN THE TUB IS FILLED WITH WATER. 10 Have questions? Call us at 1-844-44-ANZZI or visit us at www.ANZZI.
0-240V OPERATING GUIDE BUBBLE MASSAGE ON / OFF BUTTON CHROMA-LIGHT ON / OFF BUTTON BATHTUB POWER ON / OFF BUTTON POWER THE BATHTUB To turn on the system, press the power button, and the indicator light will come on. Then press either the “Light” Button or “Air Pump” button to turn on the desired Function, press again to turn off the function. (While the functions are active, the button will have 110-240V a red back light, when powered off it will have a white back light).
NEED A FREESTANDING FAUCET OR SHOWER HEAD SYSTEM FOR YOUR NEW BATHTUB? CHECK OUT ANZZI’S EXPANSIVE LUXURY BATH CATALOG. VISIT WWW.ANZZI.COM AND BROWSE THROUGH OUR COLLECTION OF BATHROOM FIXTURES AND ACCESSORIES INSPIRED BY THE LATEST TRENDS AND STYLES.
