ITEM:FS-AZ0052** ANZZI Freestanding Tub Filler V2.1 03/03/2023 R V2.
PRODUCT SIZE CHART 6.9" 175 5.9" 150 25.7" 653 2.8" 70 10.7" 272 1 / 2" male thread connection TOOLS AND MATERIALS Wrench Marker Pen Drill 1-1/8"Hole Saw PG.
COMPONENT [01] [02] [19] [03] [19] [04] [05] [06] [07] [08] [04] [09] [10] [07] [08] [09] [11] [05] [06] Part [01] [02] [03] [04] [05] Discription Check Valve Faucet Cartridge Cover Handle Qty [06] Gasket [07] Screw [08] Cap [09] Cover [10] Diverter [11] Hand Shower [12] Check Valve [13] Restrictor valve [14] Hand Shower Hose [15] Post [16] Escutcheon [17] Washer [18] Nut 3 3 3 3 1 1 1 1 1 2 1 2 [19] 2 Washer [12] [13] [15] [14] [16] [17] [18] Before installation: 1.
INSTALLATION 2 1 [02] Nut Washer [15] [15] [16] [17] [18] STEP 1: Install the Posts [15] from above through the holes of Escutcheon [16] .slide the Washers [17] onto the Post [15] from under the Escutcheon [16] and secure the Posts [15] by the Nuts [18]. Hand tighten it. Note: Make sure the outlet of the Post [15] face forward. STEP 2: Install the Faucet [02] to the Posts [15] , and secure it by tighten the nuts with wrench. DO NOT over tighten.
INSTALLATION 3 4 Mark the Escutcheon [16] center point on the floor a Hot Water Supply Cold Water Supply Supply Lines with 1/2" female thread Hot Water Cold Water b STEP 3: a. Mark the center point of faucet on the floor. Then, mark the water supply line holes beside the center point on the floor. Distance between Cold water supply line and Hot water supply line is 7.9" [200mm]. b. Drill 1-1/8" holes at the water supply line locations into the floor. PG.
INSTALLATION 5 STEP 5: Turn on hot and cold water supplies and check connections at arrows for leaks. Retighten if necessary, but do not over tighten. . 6 7 [11] [02] [14] [05] (Diver ter) [05] STEP 6: Install and secure the Hand Shower [11] and Shower Hose [14] to the Faucet [02] as the figure shows. Note: Make sure there are washers between the connections. [05] STEP 7: Turn on the Handles [05], then turn the Handle (Diverter) [05] to check the flow of spout and hand shower.
CLEANING & MAINTENANCE 1. To preserve the finish on the metallic parts of your ANZZI faucet, apply non-abrasive wax, such as car wax. Any cleaners should be rinsed off immediately. 2. Clean the flow regulator regularly for calcium build up or any blockage that reducing water flow.
