ITEM:FS-AZ0037** ANZZI Freestanding Tub Filler V2.1 03/03/2023 R V2.
PRODUCT SIZE CHART 7.2" [182mm] 9.8" 3.5" [89mm] [250mm] 8.3" [211mm] 41.5" [1054mm] 34.8" [885mm] 33.7" [856mm] 32.6" [829mm] 30" [763mm] 1.7"X1.7" [42X42mm] 0.5" [13mm] 5.9"X5.9" [150X150mm] 3/8 COMPRESSION 3.6" [92mm] TOOLS AND MATERIALS Wrench Marker Pen Drill 25/64"[10mm] Drill Bit 2"Hole Saw PG.
COMPONENT [05] [04] [06] [07] [08] [09] [10] [11] [12] [03] [02] Part [01] [02] [03] [04] [05] [06] [07] [08] [09] [10] [11] [12] [13] [14] [15] [16] [17] [18] [19] [20] [21] [22] [23] [24] [01] [11] [10] [15] [14] [13] [16] [17] [18] [19] [20] [21] Discription Housing Flow Regulator Gasket Check Valve Faucet Screw Cartridge Retainer Cover Cap Screws Handle Diverter Retainer(Diverter） Handle(Diverter） Post Hand Shower Check Valve Gasket Escutcheon Anchor Expansion Screw Inlet Hose Shower Hose [22
INSTALLATION 1 no thread 2 [16] [16] [20] STEP 1: Slide the Escutcheon [20] onto the Post [16]. Note: The unthreaded point of the Post [16] pointed upward. 3 [21] STEP 2: Install the Anchor [21] to the Post [16] and secure. 4 [23] [21] [23] STEP 3: Slide the Inlet Hose [23] through the Post [16] from the bottom of the Anchor [21]. STEP 4: Install the Inlet Hoses [23] to the Faucet [05] and secure.
INSTALLATION 5 STEP 5: . Install the Faucet [05] to the Post [16]. Align the Faucet [05] with the Post [16] . and tighten the Screw [06] to secure. [06] 7 6 marks of Anchor [21] screw holes on the floor mark of Anchor [21] center point on the floor STEP 6: Position the Faucet [05] over the intended installation spot. Mark the center point on the floor. Then, mark the Anchor [21] screw holes on the floor. PG.
INSTALLATION 8 STEP 8: a. Turn on hot and cold water supplies and check connections at arrows for leaks. Retighten if necessary, but do not overtighten. b-1. Install the Expansion Screw[22] for concrete floor. Position the anchor of the faucet through the Expansion Screw[22], slide the washers onto the anchor and secure the anchor by tighten the nuts. b-2. For the wood floor, please secure the faucet with #14 Phillips pan head self-taping screws (not provided). c.
CLEANING & MAINTENANCE 1. To preserve the finish on the metallic parts of your ANZZI faucet, apply non-abrasive wax, such as car wax. Any cleaners should be rinsed off immediately. 2. Clean the flow regulator regularly for calcium build up or any blockage that reducing water flow.
