Owners manual

5150 Eucalyptus Ave Unit A

Read complete instructions

Chino, Ca. 91710

before installation!

888.360.3696

Tools needed

Remove the 2 outer screws from

Pull the light assembly straight

Phillips Screwdriver

the stock light housing.

out.

Unclip the harness from the stock

Connect the plug from the

Re-install the light using the

light.

new light to the plug coming from

suppiled screws. Be sure to

the vehicle.

check for proper function before

operating vehicle on public

highway.

AnzoUSA™ products are covered, by a limited one (1) year warranty, to be free of manufacturer’s defects. However, certain AnzoUSA™

product categories have warranty policies which differ from this standard, please contact your representative for detailed category

information. Damage due to improper installation or road hazards is not covered. Seller and manufacturers’ only obligations shall be to

replace the product proven to be defective. Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or

consequential, arising out of the use of or the inability to use the product. Before using, user shall determine the suitability of the

product for its intended use, and user assumes all risk and liability whatsoever in connection therewith.

Application: 00-06 Toyota Tundra

Part Number: 531040

Improper installation may

www.anzousa.com

void warranty

Description: 3rd Brake light