Owners manual

5150 Eucalyptus Ave Unit A

Read complete instructions

Chino, Ca. 91710

before installation!

888.360.3696

Tools Needed

Torx Bit set

3/8 ratchet

Wire Crimpers

Wire connectors

Remove the 2 Torx screws

Disconnect the plug from the light.

holding the light to the body.

Once the light is removed from

We chose to cut the stock

Reinstall the light and test the

the truck . Clean the surrounding

connector off. You do not have

functions.

part of the cab so the new

to. The wires get spliced in the

Part Number: 531097, 531098, 531099

Improper installation may

www.anzousa.com

void warranty

Description: 3rd Brake Light

Application: 2014 and up Chevy Silverado and GMC Sierra 1500, 2015 Chevy Silverado and GMC Sierra 2500,3500

part of the cab so the new

to. The wires get spliced in the

gasket supplied with the light

following sequence.

can be applied to the vehicle.

White to White

Red to Purple

Black to Black

AnzoUSA™ products are covered, by a limited one (1) year warranty, to be free of manufacturer’s defects. However, certain AnzoUSA™

product categories have warranty policies which differ from this standard, please contact your representative for detailed category

information. Damage due to improper installation or road hazards is not covered. Seller and manufacturers’ only obligations shall be to

replace the product proven to be defective. Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or

consequential, arising out of the use of or the inability to use the product. Before using, user shall determine the suitability of the

product for its intended use, and user assumes all risk and liability whatsoever in connection therewith.