Owners manual

Installation Manual:
Part Number: 531038 ,531068
531069
5150 Eucalyptus Avenue Unit A
07-08 Toyota Tundra/Sequoia
Chino, Ca. 91710
Third Brake Light
888.360.3696
Chrome & Black Clear Amber
www.anzousa.com
Completely read all the instructions before installation
Improper installation will void warranty!
Step 1 Step 2 Step 3
Tools needed:
Remove the four phillips screws
Open the cap directly above the seat
10mm Socket on the third brake light housing belt holster to separate the inner
Trim Pin Remover lining panel
Phillips Screw Driver
Step 4 Step 5 Step 6
Remove the rubber molding Separate the lower inner lining Remove the 10mm bolt located at
surrounding the rear door frame panel from the upper inner lining the bottom of the upper inner lining
panel panel
Step 7 Step 8 Step 9
Remove the upper inner lining panel Separate the ceiling lining panel by
Remove the two 10mm bolt located
pulling down the attached plastic directly behind the third brake
screw pins light housing