Owners manual

14885 Monte Vista Avenue
Read complete instructions
Chino, Ca. 91710
before installation!
888.360.3696
AnzoUSA™ products are covered, by a limited one (1) year warranty, to be free of manufacturer’s defects. However, certain AnzoUSA™
product categories have warranty policies which differ from this standard, please contact your representative for detailed category
information. Damage due to improper installation or road hazards is not covered. Seller and manufacturers’ only obligations shall be to
replace the product proven to be defective. Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or
consequential, arising out of the use of or the inability to use the product. Before using, user shall determine the suitability of the
product for its intended use, and user assumes all risk and liability whatsoever in connection therewith.
Step 7: Test all functions
making sure everything works
before driving.
Step 4: Take out the new Anzo
light and peel off the backing
from the blue resistor and
place inside the housing.
Application:1999-2006 Chevy Silverado & 2007 Silverado Classic body style
/ 1999-2006 GMC Sierra &
Tools Needed: Phillips
screwdriver
Step 1: Locate the two phillips
screw and remove them with a
phillips screwdriver.
Step 2: Pull off the 3rd brake
light from the vehicle.
Step 3: Locate the wire
harness and unplug it from the
light.
Step 5: Plug in the new Anzo
3rd brake light.
Step 6: Screw in the light
using the two phillips screw
removed from step 1.
Part Number: 531029
Improper installation may
www.anzousa.com
void warranty
Description: 3rd Brake Light