Owners manual

14885 Monte Vista Avenue
Read complete instructions
Chino, Ca. 91710
before installation!
888.360.3696
AnzoUSA™ products are covered, by a limited one (1) year warranty, to be free of manufacturer’s defects. However, certain AnzoUSA™
product categories have warranty policies which differ from this standard, please contact your representative for detailed category
information. Damage due to improper installation or road hazards is not covered. Seller and manufacturers’ only obligations shall be to
replace the product proven to be defective. Neither seller nor manufacturer shall be liable for any injury, loss or damage, direct or
consequential, arising out of the use of or the inability to use the product. Before using, user shall determine the suitability of the
product for its intended use, and user assumes all risk and liability whatsoever in connection therewith.
© 2008 AnzoUSA™. All rights reserved.
Step7: Twist the two cargo
blubs into the new Anzo light.
Tools Needed: Phillips
screwdriver.
Step 1: Locate the two phillips
screw on both ends of the
third brake light and remove
Step 2: Take off the light from
the vehicle.
Step 5: Plug our new Anzo
third brake light into the
orginal bulb socket.
Step 4: Remove the middle
light bulb from the socket.
Step 3: Twist off the light bulb
socket from the third brake
light.
Step 6: When connecting our
new Anzo third brake light
make sure orange wire lines
up with the white/yellow wire
and black to red/green wire
Step 8: Test all functions for
proper installation before
driving.
Part Number: 531001 - 531002 - 531007
Application: 2002 - 2008 Dodge Ram
Improper installation may
www.anzousa.com
void warranty
Description: 3rd Brake Light