Use and Care Manual
Lower handle on replace body and Insert Gel Fuel cup (Part C) into Main Body (part A). NOTE: The rim of the Gel Fuel Cup will be wider than the top of the main
body to prevent the handle from being able to be lifted while in use. When in use, make sure you place the replace in a location away from trac so it cannot be
tipped or knocked over. ALWAYS KEEP AWAY FROM CHLIDREN AND PETS AND AWAY FROM FLAMABLE MATERIALS.
ASSEMBLY INSTRUCTIONS FOR USE AS A FIREPLACE
STEP 1
STEP 2
STEP 3
STEP 4
Unwrap any paper labels from around your GEL CAN FUEL if it should have any wrapped around it. Remove the lid from your Gel Fuel can, using a paint can opener
or other similar device. Be careful to not puncture the can when you remove the lid. Once the lid is removed, place the can into the cup of your replace.
Make sure no fuel has spilled out of the can. If it has, clean all of it up before you attempt to light the fuel.
To extinguish the ame, use the snuer (part B) by placing it over the cup and cutting o the air to the ame. To be sure the re is extinguished, be sure to leave the
snuer over the cup for at least 10 seconds. Always double check the re is extinguished before leaving it unattended. Once cool, approx. 10 minutes, you can
replace the lid of the can if there is fuel remaining in the can and you intend to reuse the fuel. If the fuel can is empty, be sure the can is cool before discarding it into
the garbage.
Using a long BBQ style lighter or long match, touch the ame to the fuel and it will ignite... Then ENJOY! BE SURE YOU READ ALL OF THE SAFETY INSTRUCTIONS AND
WARNINGS BEFORE USE. ANYONE WHO WILL BE USING THIS FIREPLACE MUST ALSO READ THESE SAFETY AND WARNING INSTRUCTIONS