User's Manual

MHPTV TX User Manual
MHPTV-USR-DOC-V3.0, 10/18/2019 Page 97 of 148
10. Repeat steps 3 through 7 above, this time removing, measuring, and returning
the RJCT IN sample to calibrate the Reject Load system power meter by
adjusting the value of Rejt1 below.
11. With your TX operating at your desired output power and with accurately
calibrated system power metering, the next step is to set up and re-engage the
TX AGC. To accomplish this, slightly adjust (if necessary) the value of
POWER in the Exciter RF submenu to desired TPO.
12. Navigate to the AGC screen on the Controller (by pressing the CONFIG button
and then the AGC button). Be sure the AGC Target FWD power is set to desired
Calibration for
REFL power
meter
Calibration for
RJCT power
meter