User's Manual

MHPTV TX User Manual
MHPTV-USR-DOC-V3.0, 10/18/2019 Page 93 of 148
3. Disconnect the FWD IN sample from the rear panel of the Controller and
connect this to your power meter. This sample comes from the TX output
directional coupler and has a coupling value of 50dB (offset for your power
meter). Measure and record the real Forward system power.
4. Disconnect the FWD sample from your power meter and reconnect it to the
FWD IN port on the rear panel of the Controller.
5. Monitor the FWD power meter on the Controller HOME screen and notice if
it reads higher or lower than your recorded power meter reading.
Power Meter
1000.0 W
X
FWD REF
Coupler
IN RJCT
Reject Load
System FWD
power meter