User's Manual

MHPTV TX User Manual
MHPTV-USR-DOC-V3.0, 10/18/2019 Page 88 of 148
7. Check the SNR and Shoulder (LIMD and UIMD) RF performance on the
front panel screen of the exciter or by pressing the Exciter Icon on the
Controller HOME screen. (Change the value of CFR or rerun correction if
necessary, to obtain optimal performance).
8. With your TX operating at your desired output power and with good RF
performance, the next step is to set up and re-engage the TX AGC. To
accomplish this, be sure the TX system forward power is at, or just slightly
higher than, the desired system TPO.
9. Navigate to the AGC screen on the Controller (by pressing the CONFIG button
and then the AGC button). Be sure the AGC Target FWD power is set to desired
TPO and then press the unlit AGC button to engage the TX AGC and turn this
button Green.
Set Target AGC
Power
to desired TPO
Press AGC button
to turn AGC ON
(will illuminate
Green)