User's Manual

MHPTV TX User Manual
MHPTV-USR-DOC-V3.0, 10/18/2019 Page 84 of 148
4. Operational Basics
4.1 TX ON/OFF
Local Control: To turn the TX On/Off, please use the TX On/Off button located
on the HOME screen of the Control module. The Button will light Green when
the TX is ON and RED when the TX is off. When turning the TX ON, please
monitor the FWD power wattage on the HOME screen as FWD power ramps up
to the AGC target level (which takes roughly 45-60 seconds).
Remote Control: To Turn the TX On/Off from the Controller Web Interface,
please select ON or OFF for TX_SET on the SYSTEM-SET tab and press the
SET button to the right (network to the Controller module via rear panel RJ-45
LAN connection, default IP address 192.168.1.210).
TX On/Off
FWD Power
Meter
TX On/Off