User's Manual

MHPTV TX User Manual
MHPTV-USR-DOC-V3.0, 10/18/2019 Page 83 of 148
13. You may network your Transmitter Control Module (rear LAN connector,
default IP address 192.168.1.210) and your Exciter (REMOTE RJ-45 rear panel
connection at 192.168.1.143), and your PA drawers (front LAN port
192.168.1.200 – note – you will need to change some of the PA IP address (via
the PA built-in web interface) to avoid network conflicts if putting all PAs on
your network for remote monitor/control. All equipment IP addresses are user-
configurable via their respective user interfaces, so they may be configured to
match the TX sites specific IP addressing scheme.
If you desire to have remote monitoring and control, before leaving the station,
please be sure to set the Transmitter to REMOTE mode via the Controller CONTROL
button setting and set the Exciter to REMOTE mode under the SYSTEM submenu by
setting CTL=RMT. This will enable remote monitoring and control of the TX via its
built-in web interfaces (refer to the 1KW TX and Exciter user manuals for details).