User's Manual

MHPTV TX User Manual
MHPTV-USR-DOC-V3.0, 10/18/2019 Page 79 of 148
5. Continue to slowly raise the FWD power until you reach the max power rating
of the TX or your lower desired TPO. Check to be sure that the PA device
currents do not exceed the full power operating currents as shown in your
Factory Test Report. Also, be careful to make small increases in the value of
Exciter POWER as you approach the desired TPO.
6. Check the SNR and Shoulder (LIMD and UIMD) RF performance of your
system by pressing the Exciter A icon on the Controller HOME screen or by
checking the Exciter hi-level LCD or web interface as shown below.
Monitor device
currents on all PA
drawers – be sure
to not exceed
Factory Test data
values