User's Manual

MHPTV TX User Manual
MHPTV-USR-DOC-V3.0, 10/18/2019 Page 114 of 148
5.4 CONFIG SCREEN
Touching the Config button on the Title Bar of the Home Screen will navigate to
the Config Screen, as shown below. The Config Screen has seven functional sections
on the right. Press any of these buttons to navigate to that config screen. The Network
screen is used to configure all the TX networking parameters including IP, Mask, and
Gateway. The Time screen is used to set the current time. The AGC screen is used to
turn the Controller AGC On/Off and to change the target AGC output power level. The
AmpCf screen is for configuring the PA settings, including FWD and REFL fault
threshold settings, and power meter calibrations. The Exciter screen provides Dual or
Single Drive Exciter selection. The BootSet screen establishes how many times the TX
attempts to reboot itself on power loss or fault conditions. The ClrALM screen allows
the user to clear any previous alarms. Please Note: Modifying factory default
configurations of certain parameters may lead to potential damage of the transmitter.