User's Manual

ACT-VHF-III-600PA User Manual

ACT-VHF-III-600PA-USR-DOC-V1.0, 05/29/2019 Page 2 of 26

No part of this publication may be reproduced, translated, transcribed, stored in a retrieval

system, or transmitted into any form or by any means, without the express written permission

of Anywave Communication Technologies, Inc.

FCC Compliance

Note: This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case the user will be required to correct

the interference at his own expense

The antenna(s) used for this transmitter must be fixed-mounted on the outdoor permanent

structures. RF exposure compliance is addressed at the time of licensing, as required by the

responsible FCC Bureau(s), including antenna co-location requirements of §1.1307(b)(3).

Changes or modifications not expressly approved by Anywave Communication Technologies,

Inc. could void the user's authority to operate the equipment.

Disclaimer

Information provided by Anywave Communication Technologies is believed to be accurate

and complete; however, no liability can be assumed for its use.

The manufacturer makes no representations or warranties, either expressed or implied, by or

with respect to anything in this manual, and shall not be liable for any implied warranties of

fitness for a particular purpose or for any indirect, special, or consequential damages.

Information in this document is subject to change without notice and does not represent a

commitment on the part of the manufacturer.

USE OF THIS PRODUCT IN A MANNER OTHER THAN DESCRIBED IN THIS

MANUAL MAY RESULT IN DAMAGE TO THE EQUIPMENT AND/OR PERSONAL

INJURY.