ANYWAVE ATSC VHF III 600W PA User Manual Version 1.
ACT-VHF-III-600PA User Manual Copyright Notice Copyright © Anywave Communication Technologies, Inc. 2019, All rights reserved. No part of this publication may be reproduced, translated, transcribed, stored in a retrieval system, or transmitted into any form or by any means, without the express written permission of Anywave Communication Technologies, Inc.
ACT-VHF-III-600PA User Manual PLEASE READ THIS MANUAL IN ITS ENTIRETY BEFORE ATTEMPTING TO INSTALL THE EQUIPMENT. CONTACT ANYWAVE WITH ANY QUESTIONS OR CONCERNS YOU MAY HAVE. Unpacking Carefully unpack the equipment and perform a visual inspection to determine if any apparent damage has occurred during shipment. Please notify the delivery carrier and Anywave immediately if shipment damage has occurred. Retain all original shipping materials.
ACT-VHF-III-600PA User Manual WARNING THE VOLTAGES, CURRENTS, AND RF ENERGY IN THIS EQUIPMENT ARE DANGEROUS. PERSONNEL MUST AT ALL TIMES OBSERVE ALL SAFETY WARNINGS, INSTRUCTIONS, AND REGULATIONS. IN THE CASE OF EMERGENCY, ENSURE THAT ALL POWER HAS BEEN DISCONNECTED. ALWAYS DISCONNECT POWER BEFORE REMOVING COVERS, ENCLOSURES, OR SHIELDS. DO NOT PERFROM SERVICE ON THE EQUIPMENT WHEN ALONE OR FATIGUED. KNOW YOUR EQUIPMENT AND DO NOT TAKE RISKS.
ACT-VHF-III-600PA User Manual Contents 1 Product Appearance ........................................................................................ 6 1.1 Front Panel ....................................................................................................................................6 1.2 Back Panel ....................................................................................................................................7 2 Specifications ...........................................
ACT-VHF-III-600PA User Manual 1 Product Appearance 1.1 Front Panel LED_PWR Green light will be on when the DC voltage of internal power supply is within the normal range (48 VDC ~ 52 VDC). Green light will flash when the DC voltage of internal power supply is out of the normal range (48 VDC ~ 52 VDC). Green light will be off when the external power supply is turned off, or internal power supply module does not work.
ACT-VHF-III-600PA User Manual 1.2 Back Panel RF IN Connector: N Impedance: 50 Ω Note: If input power from RF_IN is lower than rated input value, the output power will be lower than rated output power accordingly. This is because the PA has a fixed gain. If the input level from RF_IN is higher than the rated value, it will result in RF output distortion and performance deterioration.
ACT-VHF-III-600PA User Manual 2 Specifications Environment Operation Temperature: -10 oC ~ +60 oC (+14 oF ~ +140 oF) Operation Humidity: 20 % ~ 90 % (non-condensing) Atmospheric Pressure: 86 kPa ~ 106 kPa Power Supply Voltage: 176 ~ 300 VAC (full load) Frequency: 47 ~ 63 Hz RF Performance Frequency: 177 MHz ~ 213 MHz VSWR: ≤ 1.
ACT-VHF-III-600PA User Manual 3 Control Interface 3.1 Local (Controller) Interface Local control and monitoring of the PA unit can be accomplished via the Controller touch panel interface. Use a standard serial cable to connect the PA DB9 RS485 port to the Controller PRS-485-1 RS485port (please reference the 600W VIII TX QSG for the system interconnect diagram and details).
ACT-VHF-III-600PA User Manual ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual When press the AmpCf (Amplifier Configuration) Button, you will be prompted to enter Password: 27654 ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual 3.2 Web Interface The 600W PA, Controller, and Exciter all have built-in web interfaces for system monitoring and control. Below are screenshots of the PA (192.168.1.200), Controller (192.168.1.210), and Exciter (192.168.1.143) web interfaces. Enter the IP address of the equipment in a web browser's address bar to cause a login window to pop up.
ACT-VHF-III-600PA User Manual Controller web pages: ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual PA web pages: ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual Exciter web pages: ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual ACT-VHF-III-600PA-USR-DOC-V1.
ACT-VHF-III-600PA User Manual Anywave Communication Technologies Inc. 300 Knightsbridge Parkway, Suite 150, Lincolnshire, IL 60069 Tel: (847) 415-2258 Fax: (847) 415-2112 Email: sales_us@anywavecom.com http://www.anywavecom.net/ ACT-VHF-III-600PA-USR-DOC-V1.
