Instruction Manual

10
FUNCTION MENU
No.
Function
LCD
Display
Description
1
Available setting: oF, 01-09 levels
Default: oF
2
3
4
5

6
7
8
9
10
󰻨󰻩
11
12
1.
Press the [
UP
] key of the microphone to enter into the radio function menu.
2.
Rotate the channel switch or press the [
UP/DN
] key of the microphone to select the
menu function options.
3.
Press the [
PTT
] key of the microphone to enter into the menu setting.
4.
Rotate the channel switch to select the desired setting.
5.
Turn off to save and exit the function settings.
WX alarm
Roger beep
Beep
Dimmer
NPC
VOX level
VOX delay
Scan type
Micrphone type
Fine adjust
SWR display
Reset
Available setting: oF, 01-05 levels
Default: oF
Available setting: oF, on
Default: on
Available setting:1-3
Default: 3
Available setting: oF, on
Default: on ( It is valid for AM/SSB mode only, adjust MIC
to control microphone gain)
Available setting: oF, 01-09 levels
Default: oF
Available setting: 01-09 levels
Default: 3
Available setting: ti( timne scan), Sq( squelch scan)
Default: Sq
oF: turn on frequency fine adjustment.
Default: EL
r: turn on fine adjustment for RX frequency
t: turn on fine adjustment for TX frequency
rt: turn on fine adjustment for TX /RX frequency
Default: rt
Available setting: EL(condenser), dy( dynamic)
Default: oF
on: turn on SWR display
oF: turn off SWR display
NB/ANL slide switch to OFF, press PTT to reset all
NB/ANL slide switch to NB/ANL, press PTT to reset
radio data to factory default
all channel data to factory default
Note: VOX will not work if squelch is on.