Operation Manual

HOW TO USE THE ANYSEE APPLICATION
Scan Channel / ANALOG TV mode
Using the anysee E-Series and antenna for receiving the analog signal, you watch the analog TV in
home or outdoor. But you can’t measure the degree of sensitive of analog.
The performance of signal reception varies depending of the antenna capacity and locations.
Channel Scan is Auto Scan and Manual Scan.
When anysee is turned on after the installation of anysee program, a message, There is no channel.
Please scan channels first, appears. Click OK button and scan channel window appears.
1
5
7
8
6
3
2
4
* Surely, scan channel in analog TV
① Select Channel Scan.
② Set the input signal.
AIR : Choose Air to connect Whilst outdoors (Road antenna)
Cable : Choose Cable to connect Cable signal.
Country : Select country.
Analog TV : Select analog TV channel scan.
Digital TV : Select Digital TV channel scan. (Disable in analog TV mode.)
QAM Scan : Select Digital Cable channel scan. (Disable in analog TV mode.)
③ Auto Scan : If you click Auto Scan, channel search will begin automatically.
All channels are scanned automatically. If no reception has been made, check the settings of
country and reception rate again.
Stop : If you click Stop Scan, channel search will stop.
Click Stop Scan when the reception of the wanted channel has been made to stop the
scanning. Wait until Finish window appears. (Recommended)
Manual Scan : Select the channel and bandwidth for manual scan.
The frequency for each channel is different in a different country. Select a country first and
then the channel. Then the frequency will automatically change.
41 / 82