Operation Manual

HOW TO USE THE ANYSEE APPLICATION
Digital TV : Select Digital TV channel scan.
QAM Scan : Select Digital Cable channel scan.
③ Auto Scan : If you click Auto Scan, channel search will begin automatically.All channels are
scanned automatically. If no reception has been made, check the settings of country and
reception rate again.
Stop : If you click Stop Scan, channel search will stop.
Click Stop Scan when the reception of the wanted channel has been made to stop the
scanning. Wait until Finish window appears. (Recommended)
Manual Scan : Select the channel and bandwidth for manual scan.
The frequency for each channel is different in a different country. Select a country first and
then the channel. Then the frequency will automatically change.
If the required channel was not found, Not Found window appears as shown below.
④ Signal : Indicate received signal.
Check Signal: The strength and quality of signals is shown.
Strength : Indicate of receiving signal strength.
Quality : Indicate of receiving signal quality.
The signal reception rate varies depending of the antenna capacity and locations. Reception is
possible when the signal reception rate is over 60-70%. If the received signals are weak, try
moving the antenna (directional antenna) slowly left to right until the maximum reception
rate is achieved.
⑤ Show the scanned channel.
⑥ Create New Channel List : If you hope to delete the priority channel list, please check and
make new channel list.
⑦ For manual scan, please input channel and frequency directly.
The frequency for each channel is different in a different country.
⑧ OK : Exit configuration.
40 / 82