Operation Manual

HOW TO USE THE ANYSEE APPLICATION
Scan Channel / DIGITAL TV mode
Using the anysee E-Series and antenna for receiving the digital signal, you watch the digital TV in
home or outdoor.
There are two methods of scanning the channels, automatic scan and manual scan.
For automatic scan, perform the following sequence and for manual scan, move to menu for signal
reception.
The performance of signal reception varies depending of the antenna capacity and locations.
Reception is not possible if the signal reception rate is below 50-60% even if the strength of signals
is over 80%. If the received signals are weak, try moving the antenna (directional antenna) slowly
left to right until the maximum reception rate is achieved.
When anysee is turned on after the installation of anysee program, a message, There is no channel.
Please scan channels first, appears. Click OK button and scan channel window appears.
Choose a Scan Channel
1
5
7
8
6
3
2
4
*Surely, scan channel in digital TV.
① Select channel scan in configuration.
② Set the input signal.
AIR : Choose Air to connect Whilst outdoors (Road antenna)
Cable : Choose Cable to connect Cable signal.
Country : Select country.
Analog TV : Select analog TV channel scan. (Disable in Digital TV mode.)
39 / 82