User's Manual

Usage Instructions
For best results, follow this process every morning.
1. Perform daily foot exam. Continue to perform your daily foot
inspection, as instructed by your healthcare provider,
examining your feet for signs of developing ulcers or open
wounds.
WARNING: If you notice broken skin or a developing ulcer,
discontinue use of the mat and contact your healthcare provider
immediately.
2. Check the mat. Before use, inspect the mat for wetness,
damage, or discoloration. Make sure the mat is dry before using
it. If it is damaged, do not use the mat and contact Podimetrics
for a replacement. If it is discolored, try to clean off any residue.
If the discoloration cannot be removed, contact Podimetrics to
see if a replacement is necessary.
3. Stand on the mat, barefoot. To start a scan, stand with both
bare feet completely inside the outlined sensing region of the
mat. Once you are standing still, the scan will automatically
start. It will make a chime and the lights will turn on.
CAUTION: Do not use the mat with water or lotion on your feet
Correct foot position, scan started
4. Complete the scan. Keep your feet still for 20 seconds while the
scan completes. The lights will progress around a circle and
when the scan is finished, the full circle will light up and the mat
will chime again.
Scan in progress Scan complete
If either foot is on the edge of the sensor zone or moves during
the scan, the feet will light up and an error chime will sound,
indicating a scan failure. Restart the scan by placing both feet
within the scanning zone and keeping them still until the new
scan starts.
Incorrect foot position, error indication
7
8