User manual

AWR-501L (AWR Mobile Router)
AnyTime AnyPlace AnyWireless Data Solutions™ 25/39
Advanced Setup > Wireless LAN > Wireless Setting
Wlan Radio
Check whether you want wireless AP to be enabled or not.
Channel ID
Select appropriate channel ID to be used in wireless network.
ESSID
You may change network name by entering new name and clicking “Apply”
AP Name
You may change AP name by entering new name and clicking “Apply”
Operation Mode
You may select G mode only (support 54Mbps) or
B mode only (support 11Mbps) or B/G Mixed mode for both.
You may select operation mode and change by clicking “Apply”
Tx Preamble Type
Select Short or Long Preamble.
The Preamble defines the length of the CRC block (Cyclic Redundancy Check is a
common technique for detecting data transmission errors) for communication between
the AWR-501L and the roaming wireless network adapters. Recommended type is Auto
Beacon Interval
This is to notify whether or not the AP exists to PC. Its default interval is 100msec. The
range of interval is from 25msec up to 501Lmsec.
RTS Threshold
This value should remain at its default setting of 2312 if inconsistent data flow is a
problem, only a minor modification should be made.
Fragmentation
Threshold
The fragmentation threshold, which is specified in bytes, deter-mines whether packets
get fragmented. Packets exceeding the 2312 byte setting are fragmented before
transmission. By default the Fragmentation is 2312.