User's Manual

Personal GPS Locator Users Manual (ACT200-D)
All Rights Reserved.
9/12
4 HANDING THE VEHICLE GPS LOCATOR
4.1 SET-UP
1. Most of vehicle has an OBD-II (On Board Diagnostics) connector, which
is located within 2 feet of the steering wheel.
2. The installation is very easy, just put the ACT200-D to the OBD-II
connector in user vehicle.
3. The ACT200-D will power on automatically from vehicle battery and
start initiation for CDMA network access.
Figure4.1: Installation of ACT200-D in vehicle
4.2 POWER SUPPLY FROM VEHICLE (TYPICAL 13.8V)
1. After insertion of ACT200-D to OBD-II connector, the device has
automatically power-on with the car battery, typically 12~14V.
2. If the engine has off, then the device decide to power off the OBD
interface circuit, and run the CDMA module with GPS for the
unauthorized movement function.
3. If the engine has on, then the device work on the OBD interface
circuit, which is charge of gathering the vehicle information such
as fuel gauge, speed, engine RMP, and so on to report it to LBS
server via the CDMA network.