User's Manual

ACT10 Users Manual

8/11

4 H

ANDING

LUETOOTH

OBD

EHICLE

EVICE

4.1 S

1. Most of vehicle has an OBD-II (On Board Diagnostics) connector, which

is located within 2 feet of the steering wheel.

2. The installation is very easy, just put the ACT10 to the OBD-II

connector in user vehicle.

3. The ACT10 will power on automatically from vehicle battery and start

initiation for Bluetooth system.

4. After install of device to vehicle, all services are ready.

Figure 4.1: Installation of ACT10 in vehicle

4.2 P

OWER SUPPLY FROM VEHICLE

(

TYPICAL

13.5V)

1. After insertion of ACT10 to OBD-II connector, the device has

automatically power-on with the car battery, typically 9~20V.

2. If the engine has off, then the device decides to power off the

OBD interface circuit.

3. If the engine has on, then the device work on the OBD interface

circuit, which is charge of gathering the vehicle information such

as fuel gauge, speed, engine RMP, and so on to report it to user

via Bluetooth network.