Instructions

17
 If the PC has been installed CP2102 driver before, then there should be a COMx in
Ports of Device manager already.
 Sometimes, even the driver is not installed properly, it may still show an abnormal
COM x in Ports, please just uninstall the COM x and try to install the driver again.
5.2 Cura Installation
ANYCUBIC Mega 3D printer reads Gcode file and prints. It is necessary to convert 3D files
(such as stl file) into Gcode files for machine to recognize. Software that convert 3D files
into Gcode files is called slicing software. Cura_15.04.6 is used for example here.
Location of Cura: SD card--->“Files_Engish_Mega”--->“Cura”--->“Windows”.
Double click “Cura_15.04.6”, and follow the procedures as shown in Fig. 16:
(Figure 16)
①
②
③
④