Instructions

Step 4. Put a piece of paper onto the print platform, and then manually move the print head

and platform back and forth to let the print head travel to the 4 corners and center

one by one （①→②→③→④→⑤）, as shown in Fig.9. (Avoid nozzle rub against the

platform directly without the paper in-between)

(Figure 9)

Step 5. When nozzle has been moved to corner ①, manually adjust (tighten or loose) the

corresponding nut underneath the print platform.

The purpose is to adjust the distance between nozzle and print platform to about

a piece of paper thin (~0.1-0.2mm). Therefore, when just feel the drag resistance as

pulling the paper, it means good leveling for this particular corner.

(Note: “just feel the drag resistance” means the paper can be moved, but with resistance)

Please do so to the rest of corners and center area. Perform double check to ensure

the results, and check the corners in diagonal order: ①→③, ②→④.

①

A4 paper

Nozzle

Nut

②

③

④

⑤